2022 Updated Verified 200-301 dumps Q&As - Pass Guarantee or Full Refund [Q73-Q98]

2022 Updated Verified 200-301 dumps Q&As - Pass Guarantee or Full Refund

200-301 PDF Questions and Testing Engine With 604 Questions

Which Jobs Are Associated with Cisco 200-301 Exam?

Here are some of the most popular jobs that you can assume after attaining the new CCNA certification by acing the Cisco 200-301 test:

Systems Administrator;
Network Engineer;
Network Analyst.
Network Administrator;

According to Payscale.com, the average yearly salary that CCNA certification holders can get is $78,768.

NEW QUESTION 73
Refer to exhibit.

Which statement explains the configuration error message that is received?

A. It belongs to a private IP address range.
B. It is a broadcast IP address
C. The router does not support /28 mask.
D. IT is a network IP address.

Answer: B

NEW QUESTION 74
An engineer is asked to protect unused ports that are configured in the default VLAN on a switch.
Which two steps will fulfill the request? (Choose two)

A. Administratively shut down the ports
B. Configure the ports in an EtherChannel.
C. Enable the Cisco Discovery Protocol
D. Configure the ports as trunk ports
E. Configure the port type as access and place in VLAN 99

Answer: B,D

NEW QUESTION 75
Refer to the exhibit.

What is the effect of this configuration?

A. All ingress and egress traffic is dropped because the interface is untrusted
B. Egress traffic is passed only if the destination is a DHCP server.
C. All ARP packets are dropped by the switch
D. The switch discard all ingress ARP traffic with invalid MAC-to-IP address bindings.

Answer: D

Explanation:
Dynamic ARP inspection is an ingress security feature; it does not perform any egress checking.

NEW QUESTION 76
Which protocol does an IPv4 host use to obtain a dynamically assigned IP address?

A. DHCP
B. ARP
C. DNS
D. CDP

Answer: A

Explanation:
https://www.geeksforgeeks.org/how-dhcp-server-dynamically-assigns-ip-address-to-a-host/#:~:text=DHCP%20is%20an%20abbreviation%20for,subnet%20mask%20and%20gateway%20address.

NEW QUESTION 77
Drag and drop the IPv4 network subnets from the left onto the correct usable host ranges on the right

Answer:

Explanation:

NEW QUESTION 78
Refer to the exhibit. A network associate has configured OSPF with the command:
City(config-router)# network 192.168.12.64 0.0.0.63 area 0
After completing the configuration, the associate discovers that not all the interfaces are participating in OSPF.
Which three of the interfaces shown in the exhibit will participate in OSPF according to this configuration statement? (Choose three.)

A. Serial0/0
B. FastEthernet0 /0
C. Serial0/1.104
D. Serial0/1.102
E. FastEthernet0 /1
F. Serial0/1.103

Answer: A,D,E

Explanation:
Section: IP Connectivity
Explanation:
The "network 192.168.12.64 0.0.0.63 equals to network 192.168.12.64/26. This network has:
* Increment: 64 (/26= 1111 1111.1111 1111.1111 1111.1100 0000) + Network address:
192.168.12.64
* Broadcast address: 192.168.12.127
Therefore all interface in the range of this network will join OSPF.

NEW QUESTION 79
Which cloud service is typically used to provide DNS and DHCP services to an enterprise?

A. IaaS
B. PaaS
C. SaaS
D. DaaS

Answer: A

NEW QUESTION 80
Which statement about spanning-tree root-bridge election is true?

A. Each VLAN must use the same root bridge
B. It is always performed automatically
C. Each root bridge must reside on the same root switch
D. Each VLAN must have its own root bridge

Answer: D

NEW QUESTION 81
Which two QoS tools can provide congestion management? (Choose two)

A. CBWFQ
B. PQ
C. FRTS
D. CAR
E. PBR

Answer: A,B

NEW QUESTION 82
Which protocol prompts the Wireless LAN Controller to generate its own local web administration SSL certificate for GUI access?

A. TACACS+
B. HTTPS
C. RADIUS
D. HTTP

Answer: B

Explanation:
You can protect communication with the GUI by enabling HTTPS. HTTPS protects HTTP browser sessions by using the Secure Sockets Layer (SSL) protocol. When you enable HTTPS, the controller generates its own local web administration SSL certificate and automatically applies it to the GUI. You also have the option of downloading an externally generated certificate. Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-0/configuration-guide/b_cg80/b_cg80_chapter_011.html

NEW QUESTION 83
Refer to the exhibit.

An engineer is required to verify that the network parameters are valid for the users wireless LAN connectivity on a /24 subnet. Drag and drop the values from the left onto the network parameters on the right. Not all values are used.

Answer:

Explanation:

NEW QUESTION 84
A network engineer must create a diagram of a multivendor network. Which command must be configured on the Cisco devices so that the topology of the network can be mapped?

A. Device(config)#cdp run
B. Device(config-if)#cdp enable
C. Device(config)#flow-sampler-map topology
D. Device(config)#lldp run

Answer: D

Explanation:
Section: Network Access

NEW QUESTION 85
Refer to the exhibit.

Which type of route does R1 use to reach host 10.10.13.10/32?

A. network route
B. host route
C. default route
D. floating static route

Answer: A

Explanation:
Explanation
From the output, we see R1 will use the entry "O 10.10.13.0/25 [110/4576] via 10.10.10.1, ..." to reach host
10.10.13.10. This is a network route.Note: "B* 0.0.0.0/0 ..." is a default route.

NEW QUESTION 86
The SW1 interface g0/1 is in the down/down state What are two reasons for the interface condition' (Choose two.)

A. There is a protocol mismatch
B. There is a speed mismatch
C. The interface is shut down
D. The interface is error-disabled
E. There is a duplex mismatch.

Answer: B,D

Explanation:
Explanation
Our other products which you might be interested in switching Labs
www.ccieenterpriselabs.com (CE
For CCIE Security Labs www.passsecuritylabs.com
For CCIE Wireless Labs www.passwirelesslabs.com
For CCIE Data Center Labs www.passdatacenterlabs.com
For CCIE Collaboration Labs www.passcollaborationlabs.com (PCL)
For CCIE Service Provider Labs www.passsplabs.com (PSPL)
For CCDE Labs www.passccdelabs.com (PCDL)
For Juniper Labs www.jncielabs.com (JL)
For VMware Labs www.vcixlabs.com (VL)
For CCIE Written Labs www.passwritten.com (PW)
For CCIE/JNCIE/VMware RACK RENTALS www.ccierack.rentals (CRR)
For more information contact us at Email: [email protected]
Skype: cciewrittendumps
Thank you for using www.passwritten.com workbooks

NEW QUESTION 87
Refer to the exhibit. Which action is expected from SW1 when the untagged frame is received on the GigabitEthernet0/1 interface?

A. The frame is dropped
B. The frame is processed in VLAN 5
C. The frame is processed in VLAN 1
D. The frame is processed in VLAN 11

Answer: B

NEW QUESTION 88
Refer to the exhibit.

The show ip ospf interface command has been executed on R1 How is OSPF configured?

A. The default Hello and Dead timers are in use
B. A point-to-point network type is configured
C. There are six OSPF neighbors on this interface
D. The interface is not participating in OSPF

Answer: A

NEW QUESTION 89
What is a function of a Layer 3 switch?

A. flood broadcast traffic within a VLAN
B. move frames between endpoints limited to IP addresses
C. transmit broadcast traffic when operating in Layer 3 mode exclusively
D. forward Ethernet frames between VLANs using only MAC addresses

Answer: B

NEW QUESTION 90
What is a function of TFTP in network operations?

A. transfers IOS images from a server to a router for firmware upgrades
B. transfers a backup configuration file from a server to a switch using a username and password
C. transfers a configuration files from a server to a router on a congested link
D. transfers files between file systems on a router

Answer: D

Explanation:
Section: IP Services

NEW QUESTION 91
Refer to the exhibit.

Which two commands were used to create port channel 10? (Choose two )

A. Option B
B. Option E
C. Option C
D. Option A
E. Option D

Answer: C,D

NEW QUESTION 92
Refer to the exhibit.

Which route does R1 select for traffic that is destined to 192.168.16.2?

A. 192.168.16.0/21
B. 192.168.26.0/26
C. 192.168.16.0/27
D. 192.168.16.0/24

Answer: C

NEW QUESTION 93
What is the purpose of traffic shaping?

A. to limit the bandwidth that a flow can use to
B. to provide fair queuing for buffered flows
C. to mitigate delays over slow links
D. be a marking mechanism that identifies different flows

Answer: C

NEW QUESTION 94
Refer to Exhibit.

Which action do the switches take on the trunk link?

A. The trunk forms but the mismatched native VLANs are merged into a single broadcast domain.
B. The trunk does not form, but VLAN 99 and VLAN 999 are allowed to traverse the link.
C. The trunk does not form and the ports go into an err-disabled status.
D. The trunk forms but VLAN 99 and VLAN 999 are in a shutdown state.

Answer: A

Explanation:
Explanation
The trunk still forms with mismatched native VLANs and the traffic can actually flow between mismatched switches. But it is absolutely necessary that the native VLANs on both ends of a trunk link match; otherwise a native VLAN mismatch occurs, causing the two VLANs to effectively merge.
For example with the above configuration, SW1 would send untagged frames for VLAN 999. SW2 receives them but would think they are for VLAN 99 so we can say these two VLANs are merged.

NEW QUESTION 95
Refer to the exhibit.

A network administrator must permit SSH access to remotely manage routers in a network. The operations team resides on the 10.20.1.0/25 network. Which command will accomplish this task?

A. access-list 2699 permit udp 10.20.1.0 0.0.0.255
B. no access-list 2699 deny ip any 10.20.1.0 0.0.0.255
C. access-list 2699 permit tcp any 10.20.1.0 0.0.0.255 eq 22
D. no access-list 2699 deny tcp any 10.20.1.0 0.0.0.127 eq 22

Answer: B

Explanation:
Explanation
Note : Already a statement is there in last to allow SSH Traffic for network 10.20.1.0 0.0.0.127, but Second statement says deny ip any 10.20.1.0 0.0.0.255, so how it will work once it is denied. So the right answer is remove the --- no access-list 2699 deny ip any 10.20.1.0 0.0.0.255.

NEW QUESTION 96
Drag and drop the DHCP snooping terms from the left onto the descriptions on the right.